Hood mounted turn signals
- Thread starter rrTor-Red
- Start date
whayden2003
Well-Known Member
Nowhere near sure this is factory. Just know this is where mine are. Have to zoom in. Tried to zoom in and take a screen shot. File
Was to large.
Was to large.
Ronnman
Well-Known Member
See how mine are run, original wires to hood turn signals lights.
Ron
Ron
Thanks to all who posted poctures. 71RRHI- I wonder what was used to clip it up lole that. I know it's not a "Zip-tie". Also to all, the tab in the middle of the hood, I have that same tab but I've seen where that wasn't used. Wonder why?
Ronnman
Well-Known Member
Small clips, like shown in the pic below, are used to attached the wires to the hood. The ones in my original pic are the OEM clips. I bought some new replacements from R/T Specialties, see below.
Ron
R/T Specialties clip link:
1201013 WIRE RETAINER HOOD WIRES, ENGINE & ENGINE BAY, 1201013 :Mopar Fasteners, Clips & Hardware
Ron
R/T Specialties clip link:
1201013 WIRE RETAINER HOOD WIRES, ENGINE & ENGINE BAY, 1201013 :Mopar Fasteners, Clips & Hardware
I appreciate it Ron. Thanks!!
whayden2003
Well-Known Member
Sweet. Going to buy some of these. To get rid of my zip tie. And 90’s wire loom.
Thanks, did not know the clips were available, luckly my originals were re-usable, but very brittle, might buy some to have on hand
Similar threads
- Locked
