Stainless Headers MFG

[a70duster]

Hi, has anyone on this site used these type of headers? Or know of someone?

Big Block Chrysler Turbo Header- Rectangle Port Up & Forward

Thanks

 

[Doorkicker]

interesting. not really a header, more of a manifold. Looks like a turbo setup to me.

 

[#41]

interesting. not really a header, more of a manifold. Looks like a turbo setup to me.

Hence their name "Big Block Chrysler TURBO Header"

 

[a70duster]

There name is out there but it is kind of subtle.

 

[WileE]

Are you adding a turbocharger on your engine ?

 

[GTX JOHN]

Full length Stainless headers that we run
are custom made to order and cost well
over $3000.+ at a minimum.

However, they will last a lot long than any of us will!

 

[33 IMP]

I believe somebody on A-body side had something similar for sale. Said it flat-out wouldn't fit an A-body without removing inner fenders.


And I think there are cheap (chinese?) versions on ebay and amazon.
If I wanted good stainless, and good workmanship, I think $1200 would be a good starting point.

 

[Doorkicker]

Hence their name "Big Block Chrysler TURBO Header"

BWAHHAHAHAH!!! I'm such a dork. I totally missed that... I was just looking at the pictures My only excuse... pre-coffee post!

 

[Fran B]

It's an ebay ad but you can buy else where.
https://www.ebay.com/itm/2763920800...690496&loc_interest_ms=&loc_physical_ms=44767

 

[a70duster]

I believe somebody on A-body side had something similar for sale. Said it flat-out wouldn't fit an A-body without removing inner fenders.


And I think there are cheap (chinese?) versions on ebay and amazon.
If I wanted good stainless, and good workmanship, I think $1200 would be a good starting point.

I have talked with the manufacture and they state that the dimension between the flange and opposite side is just over 3 inches. I do have an A-body and it measures 3 1/2" between the exhaust port and the shock tower. So there is a little room.

Any chance that you have a link to that post regarding the fitment issue? I've looked through the A-body site and hadn't found anything.

 

[33 IMP]

I have talked with the manufacture and they state that the dimension between the flange and opposite side is just over 3 inches. I do have an A-body and it measures 3 1/2" between the exhaust port and the shock tower. So there is a little room.

Any chance that you have a link to that post regarding the fitment issue? I've looked through the A-body site and hadn't found anything.

I think he was trying to sell em, so I'd look in parts for sale.

 

[BSB67]

Full length Stainless headers…..cost well
over $3000.+ at a minimum.
………they will last a lot long than any of us will!

Two good reasons to not go this route…