FOUND WINDOW EDGE MOLDING

[62savoyguy2]

In am looking for a window edge molding for a 64 Dodge Polara 2 DR HT. It is the molding that the drivers door window goes into and seals to the rubber on the rear window. Please see pictures... I have a pair for a 62 Fury 2 DR HT but it is 1/4 inch longer. It is held on by a rivet but a pop rivet will not work so I was thinking about putting a roll pin in to hold it in.... any other suggestions? Thanks.

 

[dartforforty]

Dennis this is from a 65 Belvedere two door hard top. Let me know if you can use it
Ed

 

[62savoyguy2]

Yes Ed that is it...How much shipped to 06062. CT.

 

[62savoyguy2]

I also measured it and it is about 16 and 3/4 inches long...
See pic