On the front glass he uses the long ones across the cowl like I've shown in the pictures.
The short ones go up the A pillar and across the roof.
The back are different.
I'm sure they are all the same size on the back glass.
But they are different from the front clip, I noticed.
For one thing they don't have a little curve in them for a removal tool to get in them like the front glass does.
I don't think Chrysler ever intended the rear glass to come out.
The factory service manual DOES give instruction for replacing the back glass though.
Also notice there is almost no gap between the rubber and the body.
The repo rubber I got had gaps at the bottom corners.
You could see light through it.
The people that made it told me they almost gave up on reproducing the rubber.
(I forget exactly who that was so I'll not try and say a name).
I'm getting ready to go in with the trim and I saved this so we would know where the clips are located if the trim ever needs to come off.
These are factory positions.
Edit.
I need to put a disclaimer.
I MAY have moved some one or two millimeters due to enlarged holes or thin metal.
I can't remember.
Particularly the two on the bottom corners that are close together.
But I'm pretty sure that they are very close to where Chrysler put them.
Probably the factory didn't even get them all in the same on every car.