WTB old school Hilborn injection W2 intake

[Highwaystar]

Looking to build a nostalgia 65ish A-body drag car. I have the motor, looking for an intake for W2 heads to complete project. if you have any leads on one, PM me.

 

[sam dupont]

few years old, but...

https://www.jalopyjournal.com/forum...block-mopar-340-maybe-273-pump-drive.1106989/

 

[Highwaystar]

few years old, but...

https://www.jalopyjournal.com/forum...block-mopar-340-maybe-273-pump-drive.1106989/

I followed up. Already sold.

 

[rt1976]

I followed up. Already sold.

I run a hilborn on my LA headed small block. The hilborns are few and far between and based on my discussions w/ them only made in the late 60's. I do not believe they ever made one that had the w2 port alignment. I have been trying to solve this problem for a while as I need a better set of flowing heads. Are you looking to race competitive or just run at nostalgia events?

 

[rt1976]

pics of my setup in various configs over the last few years. I had 12" stacks on it when it was a 426 stroker, I dropped it down to 366 per our #/ci rules and it liked the 6" stacks a lot better to the tune of around 25hp

 

[Highwaystar]

I'm looking to build just a nostalgia bracket car. No class racing. I have a stroked X block motor to 366 c.i with W2 heads and a race 904. I was hoping to find something that would bolt up to the W-2 heads. Nowadays you have options with heads that will flow good numbers with the factory intake bolt pattern. This motor I have is an old school Arrington motor from the 70's, with A modern day cam profile.

 

[rt1976]

I'm looking to build just a nostalgia bracket car. No class racing. I have a stroked X block motor to 366 c.i with W2 heads and a race 904. I was hoping to find something that would bolt up to the W-2 heads. Nowadays you have options with heads that will flow good numbers with the factory intake bolt pattern. This motor I have is an old school Arrington motor from the 70's, with A modern day cam profile.

I have an Engler Injection set up for a w9. It should fit with a little adjustment slotting off the bolt holes. I bought it for a possible W2 set up but don't plan on going that route. Let me know if you might be interested in that.
Tried to PM you but your inbox is full.

 

[Highwaystar]

I have an Engler Injection set up for a w9. It should fit with a little adjustment slotting off the bolt holes. I bought it for a possible W2 set up but don't plan on going that route. Let me know if you might be interested in that.
Tried to PM you but your inbox is full.

My PM is clear now.

 

[Big bill]

pics of my setup in various configs over the last few years. I had 12" stacks on it when it was a 426 stroker, I dropped it down to 366 per our #/ci rules and it liked the 6" stacks a lot better to the tune of around 25hp

View attachment 1161461 View attachment 1161462 View attachment 1161463 View attachment 1161464

That is bad love it!!!

 

[rt1976]

Sorry I forgot to send these. I could not upload them in the PM. I'll take $250 for them shipped.

The Engler Butterflys I have are for SBC. The Bolt pattern is slightly different. However, you can get a set from them.

https://www.englermachine.com/