Recent content by 19polara64

Wilder cam bleeds off cylinder pressure

your inbox is full. I’ll take the module and coil.

FBO Ignition Systems MOPAR Micro-Processor IGNITION SYSTEMS Digital Micro Processor Circuitry|EPROM Processor with|Built in DEAD STOP Algorithm REV Limiter|Eliminates Ballast Resistor|44KV Output on demand|Plug and Play|one simple wiring modification

Tti 1 3/4” and 2” go back to 62 1 7/8” start at 66

Howard’s cams says 1.5-1.7 thousandths on big block hydraulic lifters

PM sent

Contact your bank or credit card whoever you used for Zelle. You have recourse if you’re scammed.

This is obvious to me. When I was 17 I had a 70 duster with a 318 stickshift. I would repeatedly floor it till the valves floated and side step the clutch! Went through 3 engines 2 transmissions and the rearend. 8 3/4 fixed that. Dumb kid stuff but boy was it fun smoking those n50 15s!

I’ll have to take some measurements and do some research

He worked on everything. Kingpin reamer is probably the winner! Thanks for the input!

My dad was a machinist/machanic so could be anything.

Yup use it all the time! Here’s my thread Molassas tank results

Yup use it all the time! Molassas tank results

Interested in the heads and the main studs (are they ARP 140-5402). Thanks. Though I’m sure I’m a ways down the list lol. Rene’

But the world really is flat!