• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

451Mopar's latest activity

  • 451Mopar
    451Mopar replied to the thread The cost of a paint job..
    Maybe they are using BASF Glasurit paint.
  • 451Mopar
    451Mopar reacted to twecomm's post in the thread 66 Charger, Turn signal repair with
    Thanks!
    Thanks!
    .
    Recently had problem with L rear brake lamps not woking when braking on my 66 Charger. Looked over the schematics and decided had to be...
  • 451Mopar
    451Mopar replied to the thread which coil?.
    I was going to say I have used the MSD chrome cannister coil before with the stock type ECU, but I haven't used a factory electronic...
  • 451Mopar
    451Mopar replied to the thread The cost of a paint job..
    The cost of automotive paint is crazy. I think they figure insurance money is paying for most repair work to they charge hospital...
  • 451Mopar
    451Mopar replied to the thread Fitech 6.
    Is it rich just when starting and warming up? That is the displays shown. I have a 4-bbl FiTech, not 6 pack. Makes sure you don't have...
  • 451Mopar
    451Mopar replied to the thread AC yes or no.
    They are not that hard to install unless your engine accessories are way different than stock. Actual install time should be less than...
  • 451Mopar
    451Mopar replied to the thread AC yes or no.
    I put Vintage air kit in the 1969 Coronet. For the Plymouth $2,383 1969-70 Mopar B-Body with Factory Air Gen 5 SureFit™ Complete Kit
  • 451Mopar
    451Mopar replied to the thread One wire alt upgrade.
    Run alternator to battery through your new fuse. Do not use the original alternator wire at all. Get a multi-relay / multi-fuse power...
  • 451Mopar
    451Mopar replied to the thread SRT6 Crossfire with a wing..
    I considered getting one, but I'm to big and fat to fit in one. they are small inside. BMW Z3 has alot more room. I'm told the...
  • 451Mopar
    451Mopar reacted to SteveSS's post in the thread Favorite and least favorite Halloween candy? with
    Agree
    Agree
    .
    Admit it. You eat some of the candy before the trick-or-treaters come by. I heard this discussion on the radio. Least was circus...
  • 451Mopar
    The Leanburn seems to have about a 45-degree phase. on a stock distributor locked out, re-drill the reluctor pin slot about midway...
  • 451Mopar
    451Mopar replied to the thread Edelbrock Pro Flo XT.
    Anyone willing to fund / help fund a 512 Low deck vs. 512 tall deck comparison? pretty much only difference is rod length. I pretty...
  • 451Mopar
    451Mopar replied to the thread Fuel Line Flare.
    Thats a deal. I have the Eastwood one that looks the same at many times the cost. When using fuel line over a steel line, the flair is...
  • 451Mopar
    451Mopar reacted to icetech's post in the thread Fuel Line Flare with
    Like
    Like
    .
    * if you make your own lines.. get nickle copper... OMFG..... i didn't listen and when i finally did it is soooo insanely easy to work...
  • 451Mopar
    I was just curious in case I decide to sell my 1969 Coronet R/T hardtop project car. This is the car I plan to put the 6.1L Gen III...
Back
Top