Recent content by 66Newport

Dipstick hitting crank maybe? Dented oil pan? TQ bolts as mentioned above. Fan misaligned hitting something? Shaking exhaust shaking something else? I've seen them all. Don't forget sound travels too.

I always tighten stubborn bolts like that. I have gotten many to move like that. Just a little then back and forth. You should have a little bit of room to tighten and then reverse.. Give it a shot. Just go easy so you don't strip it or snap it off.

If you just acquired it, was the brake work recently done by PO? What's the fluid level? Air in line? Any change in idle when applying brakes? As far as temp, I would use an infrared non-contact thermometer to get an exact number. Depending on many factors, brakes can feel warm/hot which may or...

Thank you for the replies. To answer @R413, it is a stock motor with 70k miles on it. Sounds straightforward more or less. Will follow up with results when I have them.

Whatever happened to this adventure? Curious to see how you made out.

Looking to help a friend with an intermittent ticking lifter. This is a low mileage LA 318. The tick will go away for 100-200 miles then come back. It then disappears fairly quickly on warm up. At this point we would like to pull valve covers and take a look. I've searched threads high and low...

You can use a reducer in the vac line to steady the needle. Sounds like you're good though.

It's very possible that you uncovered a problem that was going to happen anyway. Better to happen in the garage than on the road. Can you at least crack the lines on the master to see what is going on there? You originally said you wanted to bleed the system. Why? because of the wheel cylinder...

What's the pedal doing (hard/soft/going all the way down or stuck at the top of its travel)? Perhaps crack some lines and see where you have flow and where you don't. Start from the master and work back.

I'd say #1 is making sure the transmission shift point adjustment is right (or at least close). Did you install the trans? If not, did your mechanic at least get it close? If the 1-2 is late or early you have some adjusting to do. That will kill a trans quick.

I know that modern "smart" battery chargers tend to fail out batteries prematurely so that you'll buy a new one. People just toss them not knowing they can be saved. I have resuscitated many (not all) batteries from our local dump; everything from car/lawn&garden down to alkaline batteries.. I...

Should be running.. There are good youtube videos that show how to do it. Search on Chrysler Master Tech Power Steering Checks and Adjustments for your year..

Like WileE said, observe the engine running when in the dark. Let your eyes adjust and look for hard arcs. You will see some but you're looking for trouble spots that should be relatively bright. You may have a plug arcing to the head where you can't see it. And stay clear from the engine when...

HB shifted and you are overadvanced/retarded? I've seen it more than once.. any progress?

Pull a plug or two after you've run it to temp and see what they look like. Were you trying to remedy a problem when you rebuilt it or was it running fine before? Are you absolutely sure the wires are installed correctly per firing order?