• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Recent content by 69hemibeep

  1. 69hemibeep

    Classic Industries Disc Brake Conversion

    Yes just look under 1973-89 A-bodies
  2. 69hemibeep

    Classic Industries Disc Brake Conversion

    Looks the same as Right Stuff that Summit Racing sells. Single piston A-body calipers they work good.
  3. 69hemibeep

    Best of Show

    Love the 70's paint scene
  4. 69hemibeep

    Windshield installation 1966-70 B body

    Spray bottle of very soapy water is your friend. I've done a bunch of these and when the word gets out you know how your in trouble LOL
  5. 69hemibeep

    440 heating only on highway speeds

    220 is at the top of the normal operating range just as long as it doesn't keep going up. Got a spring in the lower hose?
  6. 69hemibeep

    Found my build sheet! Need help softening paper

    I had to steam mine open it was wadded up like trash
  7. 69hemibeep

    The Dorks have gone next level!

    Guess I'm a Dork with red lines
  8. 69hemibeep

    What are 68-69 Charger Dash and VINs going for?

    Only issue I see is getting pulled over for a stolen plate being registered as a Ford.
  9. 69hemibeep

    What carrier bearings and races do I need?

    Got it thanks
  10. 69hemibeep

    What carrier bearings and races do I need?

    I'm doing a swap 489 bearings don't fit the 742 carrier
  11. 69hemibeep

    What carrier bearings and races do I need?

    Clutch type LSD 1-11/16" on the carrier and 489 case 3-1/4" OD on the race.
  12. 69hemibeep

    Rear fender mud flaps

    Get some curb feelers to go with them :lol:
  13. 69hemibeep

    8 3/4 Axle issues

    Seals are removed spacer and buttons are removed
  14. 69hemibeep

    8 3/4 Axle issues

    Standard axles
  15. 69hemibeep

    8 3/4 Axle issues

    I don't see any daylight between the bearing and the axle where it stops I have to take it to a friends place and try his press. I did slip the axles into the housing and have roughly 2" between the ends. Not sure what that should be
See more
Back
Top