Recent content by 70rrclone

Im interested. Do you have pics?

I have a set of comp 924-16 with break in run time. 1.900 installed 112lbs seat and 355 open. $100 shipped in the lower 48

have a set of TFS-16094-16 valve springs i removed from my TFS 240 heads. They have never been used. 1.900 installed height. 175 seat pressure. 442 open. $300 shipped in the lower 48.

Looks a lot like the speedmaster set.

Looks like the pins are riveted. Not sure how they used to be done. Not sure im going to run these.

I bought a set of speedmaster 1.5 stainless steel rockers on black friday. They arrived yesterday. The oil holes in the rocker shafts are miss drilled. Here's a pic of the speed master shaft next to a mancini branded Harland Sharp shaft. I haven't been able to get ahold of speedmaster yet...

I will watch this closely, was the melonized gear pressed on the shaft correctly or bought complete? Im in the process of switching to a solid roller. Im going to use a composite gear that i will have to press on the shaft.

Seen in Denver this morning.

Its hard to tell without measuring the hole size. If it measures 3/4 you can use one from a 78 ford truck.

.

This is all im putting up this year.

Tin indian

Tin Indian

I joined and went to the POCI event in Louisville in June. There was a lot of cool cars. The swap meet was lacking though.... I did find 2 sets of wiper arms for my satellite for $10 a set. :lol:

Bidding war drove it to 64K