Recent content by 72Satellitescoop

I tried to contact the manufacturer wilpak and got voice mail . Left message . Sent two emails as well with no reply. I tried to play around with them but you just cant compensate for the needed width in the upper corners. Really wanted these to work have not figured out a way to cover the...

I agree those factory louvers are the way to go. Can't find them. Where can you get the aluminum ones? I did not see those offered through Wilpak

Ordered a rear window lover from autoaccesoriesgarage.com. Item arrived about 7 days later and was packed well with no damage. They had a good sale price and I was looking to add these to my car. I know the stock are they way to go but very hard to find and high prices. Thought I could give...

Nothing at all and bad website for support of any kind.

Looking forward to anybody posting a pic of this setup using the seatbeltsplus.com replacement belts.

Happy Spring Gang- Purchased a set of seat belts from seatbeltsplus.com. 71-74 B Body Conversion set. Everything looks quality and it was shipped damage free and quick. Wondering about installation. I get the buckle side of the belt that bolts into the tunnel area on both sides of my console...

72 SSP with 340 and 727. Was wondering if I need a longer driveshaft. My car has a vibration somewhere in the drive line and was considering a balancing of the driveshaft but upon further inspection, I noticed about 3.5 inches of the yoke is exposed. It may have been a little smaller area...

Thanks for the input mopar brothers! Going to get it into a trans shop tomorrow. I've never touched anything inside the case and I need somebody that knows there s**t to take a look at things and see what else is rigged for failure. I'll fill you all in on where this goes.

72 SSP-340ci-727- floor console shift I've been having a leak from the rear of the trans and changed a few gaskets but the leak persisted. I believe the leak has been identified and it looks like the prior owner put some orange/copper permatex in an opening on the back of the main case. It's...

Preparing to replace entire rear drum brake system on my 72 SSP. The outside of my rear brake drums- on the wheel side -measures approx. 10.50 across. Standard brakes were a 10 inch drum with an 11 inch upgrade option Would this drum that measures 10.50 be the 11 inch drum? Never replaced the...

Thanks for all the replies. Those M/T 's are a good looking tire on that Fury coloradodave. I'm leaning toward the M/T's. JG1966- what's the backspace measurement on those on those Weld's? What kind of room do you have on the front and back of those Kelly's? I looked it up and that's a...

Looking for a picture of your mopars rear tires if you running a 30' or 31' diameter rear tires. Just got my +2 inch springs installed and it's skyjacking. Need to fill this big cavity with some meaty rubber. All 30-31's I see are a drag/street radial- M/T or Hoosier, I like the look but can't...

It's definitely up there but the small wheels really make it look even crazier. And the angle on that rear end pic is from the from the ground looking up, so it's kind of exaggerated. If I had a bigger tire in there right now-maybe a 30' diameter, it wouldn't look so bad. My original post was...

Finally got the new springs installed and oh boy is it jacked up. Passenger side wheel well height went from 24.75 to 30.90 inches. ( Driver side sits about .75 lower- about 30 inches). Way higher than I thought it would end up. No I need to find a new wheel and tire to fill this big opening...

I just love the input from the senior members of the forum. So I ended up unintentionally disconnecting the cable at the pedal and it pulled thru the firewall. This gave me a little play to try and hook the cable up to the bracket correctly as you guys have mentioned. With it still connected...