Recent content by 78cordoba

I'm looking for an exhaust system for my 78 Cordoba with a 400. All I have are the exhaust manifolds currently. Thanks.

Are two groove valves not strong enough for a low budget cruiser?

Late update the intake has positive valve seals and the exhaust has umbrella and they are all two groove valves

Thanks for all the suggestions I have decided to go with the lunati 701 cam

@T2R9, You dont happen to have a video of how it sounded do you?

https://www.forbbodiesonly.com/moparforum/threads/452-heads-valve-springs.221929/#post-911936128

Yes i have set of new summit lifters. Im unsure what springs are on the head. I was told i should be good to run them by one of my local mopar gearheads. But i may get new springs and retainers to be safe. Ill post the head thread link

@Mike67 That would be nice but yeah unfortunately not in the budget.

Im looking to run the stock torque converter

any update?

Its on a chrysler 400 bored .040 over

Hey all, I am looking for some suggestions on what cam to go with. I'm planning on keeping it pretty mild. I was just going to do a stock roadrunner cam with KB 240 pistons and a Edelbrock 1407. Other than that is basically stock. Then I realized the 68 roadrunner cam I was going to put in had...

Yes i have top rings gapped at .028 and bottom at .018 kb pistons require more end gap on upper ring

Probably a stupid question but i see these say 4.381 where the other other ones said 4.382 will that make any difference?

Hey all. I endend up snaping one of my rings during installation. I made some calls and cant get just a set for one cylinder and I have to buy the whole set. Im curious if anyone has an extra one. I need the #2 ring part number 4342AM8.040 thanks!