Recent content by bobby lee

thanks for the input guys

Looking to remove A/C unit and install just bracket pulley, can't seem to find any chargers w/o AC, am I not looking at the right places, right now I'm using the A/C compressor with no guts in it because I need the pulley for the belt to make it around the water pump. thanks , bobby lee

Thanks for all the input, everything working fine

thanks for the help guys, running great

thanks 57 appreciate the help - - - Updated - - - hope this pic shows up

put rebuilt tranny in my 72 charger with reman torque convertor, was dry when I installed it, do I need to pull it back out and fill it or will it fill when I start up the motor, any answers? thanks for the help

still trying to figure out how to use this forum, posting a couple of pics I took

still trying to work out the mounting bugs

thanks for the info, much appreciated - - - Updated - - - thanks for the info

Patrick, yes it's the half moon port above center ports, can't find the plates in any gasket kits, pic attached

thanks for the advice tallhair, will look at that solution.

got a 1972 dodge charger, installing a 74 318 motor, my 72 intake leaves open the AIR ports, is there a plate to cover this or do I leave open, any help, first rebuild

Got a 74 318 motor with a 72 intake manifold, the AIR ports (half moon in center of head on manifold side is open to outside, manifold does not cover these ports, do I need a different manifold or is it ok?

REBUILDING FROM THE JUNKYARD, HAVE MANY QUESTIONS , hoping to find the guys with the answers, looks like I may have found the right place