Recent content by Brandon4401968

Been a while since I had posted but thought I would share. Finally got the parts I needed to complete this, turned out pretty good I think.

If I can find another cheap donor truck for the parts, I would do it.

If I decide to do another one I'll let you know. Nice truck by the way..

Still have a ways to go but very happy with this so far. I'm getting another truck so I can use the axles and transfer case to make this a 4x4. Hope you enjoy.

Thanks, appreciate it and thanks for the tip. I will try that on the ramp truck I'm going to do for the Challenger to go on.

HaHa!! No, that would be a bit much.

I'll have to try that, thanks.

Thought I would share my Challenger project I just completed. First time using an airbrush and although I'm not completely satisfied, I'm pretty happy on the way it turned out. The weathered look is pretty hard to do, for me anyways.

Went up to Walmart and got a picture of my car put on an 8" x 20" wall mount. I thought it was pretty neat so figured I would share. $20 and a half hour later, it was done. I'm going to get one done for my brother with his car. The top pic is what I downloaded on their computer from my phone

Found these when out fishing

I picked up a Leatherman skeletool last year, best pocket knife I've had so far.

I was told it was hot tanked, the block needs a good cleaning though.

Thank you for the feedback, I was told it's a 67 block, was Sonic checked and bored 30 over . I didn't get the Machining done myself as it was done before I bought it. It will be 99% Street driven and would like to build it to around 500 HP. The Cam bearings were installed but that also has me...

Getting ready to build a 440 I bought not too long ago but I have some concerns. As you can see there is some pitting around the water jackets and as I was bolting it on the stand, I heard some rattling and found an old freeze plug and some debris in the block. The block has already been...