Recent content by Bsb

I have a 47th week of 1966 Hemi distributor up for sale. I can deliver to Chryslers at Carlisle. 2642482 P 476 Price: $650

I am posting some Hemi parts that I have available for sale. I will be at Chryslers at Carlisle this year and can deliver there if preferred by the buyer. 1966-67 Bell housing 1967-69 172 tooth flywheel 1967-69 direct drive rebuilt starter Price: $1,850

Yes, they're probably only an inch in length. They connect the long roof piece to the short A pillar section. I need 2.

Would you by chance have the 45 degree roof to A pillar trim pieces as well?

I have a set of 5, with center caps, Magnum wheels. They are 15x7 big bolt pattern. They came off my ‘69 Coronet. All are in good condition with a little rust spots here and there. I think an afternoon of polishing will probably alleviate most of that if not all. I am located in Hampton Roads...

Looking for a decent set of door panels (front and rear) for my 1969 Coronet. They don't have to be perfect if the price is right. the interior is black but I can always hit them with some dye. Let me know what you have and a price. Thanks, Ben

For sale is a 2006 Dodge Charger R/T with a 5.7 Hemi. The engine was recently replaced with a refurbished 5.7 Hemi from Pro Engines. The motor has 100 miles on it (will increase as I drive it) and the chassis has 106,000, overall, low for the year. Black metal flake exterior and black/grey...

$200

Price reduction: $260 again, can deliver to Carlisle.

Motivated seller... I am open to offers on the item. I will knock to $400 but am still negotiable on that price as well.

I have a set of the black Mopar Performance Valve Covers. What you see in the picture is what you get sadly, I don'y have the other items to complete the set. That being said, the price is $100. Also, there are three scuff marks from when the previous owner allowed the engine to rest on the...

I have an 11" Clutch, Pressure Plate and 143 tooth Flywheel (23 Spline) for sale. I am not aware of the brand on these items or any in depth information. I have personally never used them. The Clutch and Pressure Plate look to be unused. The Clutch Disk itself mentions it was manufactured in...

I have a Pertronix Flame Thrower III Distributor and Coil for a low deck Mopar motor. I have never used it and honestly do not know anything about it. I bought the car from someone and this came with it. From my very elementary research on the device, the price range varies drastically. I will...

I have a center section which I pulled from the rear end in my 1969 Dodge Coronet. No issues that I can tell with the item and to be honest, I think when I pulled it, it was the first time it had been separated from the housing. (I replaced it with a 3.91 sure grip) I will be at Chrysler's at...

Thanks a bunch for these photos! I appreciate your help! I got all of the clips in, now I just need to finish cleaning 50 years of dirt off the glass.