Recent content by Buckeye Bird

Thanks for your help. Just ordered (alleged to be correct) NSO unit. Now we will see if it works. $180.00 gamble!

Are there any known sources for the OEM dual function vacuum advance unit (10 degrees electric retard at idle) for 70s big blocks?

Installed silicone fluid in a 69 A body/drum restoration in 1995 and fluid is as clean today as it was then and no leak issues ever. I am sold on silicone in dry, older pre ABS brake systems, where Dot 3 is specified. Thanks!

Have others that have purchased repop factory original brake proportioning / metering valves had leakage problems? I have purchased two different valves and both have leaked. I assume they must be made off shore and all the vendors get them from the same source. One would think that a safety...

Those of us left, that worked daily in a Mopar dealership in the 1970-80 timeframe, remember the the worst part of the 8 3/4 tapered axle bearings were their poor grease sealing characteristics. Even with their double grease seal design, leakage and the resulting saturated brake shoes created...

Used Por-15 manifold coating and followed their process of media blasting and prep. Looks as good seven years and many miles later today.

Do you have a source for B or RB new vacuum cannister with OEM point distributors?

Cannot find any vendors that supply new OEM point distributor vac. cans for B or RB blocks. Any suggestions? Thanks in advance!

Any suggestions or recommendations on a competent radio repair source? AM is out on the original OEM Phillips AM/FM stereo. Thanks in advance for your input.