Recent content by c.moo

How much does the stock hood on a 63 Plymouth b body weights? Thanks

Had a 2011 dodge ram pickup gen 3 hemi it wiped out a cam and roller lifter on number 5 , it had 125,000 miles on it and seems to be common problem on gen 3 Hemi's , , they say it's not changing oil on time ,letting the engine idle to long , coating on cam flaking off etc and they say update it...

Looking for a 63 or 65 Plymouth b body rust free trunk lid . Thanks

This is on 63 Plymouth bev. , had to replace right side door glass channel that the glass sits in , got one from a 64 , same thing but the window channel is not as wide as the 63 was the glass thinner?

Looking for 1963-65 b body 2 door sedan front pass side window glass channel.

63 doesn't have bedding tape on bottom of vent window , got it apart , figure it out ,62-65 b body has two bottom pieces that sandwiches the glass with gaskets on each side , there are two screws that hold it together at the bottom, the trouble i was having problems with was the screw set up...

Already past all that , need info on how to remove glass from pivot assembly on bottom , already got wing assembly out of car.

This is on a 1963 b-body , how to disassemble the bottom part of vent wing pivot assembly , have latch off . Going to replace with new chrome pivot bottom assembly. Seen somewhere how it is done and search everywhere can't find it . Thanks

Have 63 B-body single speed wiper motor, all clean and painted, tested it, it runs but try turning it by hand and its hard to turn is this normal? Does anybody rebuild these or can you buy remans ? Thanks

They are the same thing. Thanks

Sprayed on or roll on and is it easy to keep clean, had a truck that had bedliner on it ,never haul anything in it that would damage it but it was hard to keep clean ,gravel dust and red clay dirt dust left a flat dull chalk look and wouldn't come clean , look like it was on there for years.

I will take couplers off, they need checked out anyway and check the length of shafts, the couplers have so much crud on them not getting right measurement.Thanks

Both steering shafts are for power steering and couplers on both , one is from 63 and 64 b body car , got them mix up ,one is half inch longer, need length for the 63. Thanks

Looking for 1963 b -body 2 door sedan post drivers door .Thanks

Have 2 440 blocks a 1976 and 1978 , they both have a R one side and a 9 on the other side .