Recent content by Craig

PM sent

I would like to purchase these. PM sent

Standard gauge cluster for 68 - 69 B-body. I was told that all of the gauges worked when pulled, but I could not verify that. I purchased it for a car that I no longer have. $100 plus shipping.

Safe-T-Caps Mopar B-Body rear frame repair caps. These are for the front half of the rear frame. Used for rust repair or for strengthening/stiffening the rear frame. I bought them new for a project and going another direction, so I don't need these. Brand new, hasn't been out of it's original...

Thanks for all of the replies, Looking for the best, not necessarily the cheapest, so I think I will pay the extra cost for Trimparts

Looking to purchase a set of 68 side marker lights for my Super Bee. I have read that Trimparts has good reproduction lights, but from the pics they look the same as other vendors that sell them for a fraction of the cost. Does anyone know if there are multiple mfg’s of the side markers for the...

Thanks for the replies. It will be a street driven car with max rpm probably not over 6k rpm. That picture looks like it would hit the pickup tube, although it sounds like some people have it configured with the internal pick up. Think I will buy the pickup and see if it fits in.

I have a Callies 572 4.5” stroke Hemi that I would like to use the stock 426 oil pan and pickup on. Has anyone tried this to see if the pickup will clear the crank and rods? I am putting this into a J code 68 Super Bee and would like to keep it as stock looking as possible, so trying to avoid...

Hi, I am to, looking for the tail panel trim hardware. No luck yet. Might have to purchase another trim set just for the fasteners. But the grill, you can get the mounting hardware kit for the entire grill from MegaParts. It was reasonable and matched the factory hardware perfectly.

Hi, I would like to purchase this. Tried to send a PM but your message box is full. Thanks, Craig

Still looking for these. Thanks, Craig

Hi, Those don’t look quite like mine. The ones on my 68 Coronet look wider. You can see that there is about 2.5 inches behind the large opening to the rear of the brace. Yours look like they have about a half inch. Are those from another body style, or years

That’s for the Charger. Rear window is completely different between the Charger and the rest of the B bodies. I also called AMD to see if it was in their future to reproduce it for the non Charger b bodies and they said they don’t have any plans to do so.

Hi, Here is the rear roof brace that I need. First three pictures are all of the same part. Pictures were taken from inside the car looking up, out the back window. This brace is also part of the upper rear window channel as well. Last pic is of one side of the two wheel well to dutchman panel...

Great, thanks for replying I will post them tomorrow Craig