Recent content by Dukeboy

For sale. "489" Sure Grip chunk. Unknown condition, unknown gear ratio as it isn't stamped. Located in Appomattox Va. $900+ shipping.

Got the offset dead nuts. Not all the weight is on ground as I only have one side mocked up but you get the idea.

Does your truck Dana 60 that you custom fitted to your car not have a factory provision for a pinion snubber? Well, here at F&P Performance we say "NO EFFING PROBLEM!"

That's the dummest thing I've ever seen. Why the hell wouldn't Chrysler make a different filler neck that stuck out further and seal directly to the flip cap? That seal is a hack job at best, even factory. Amazes me how many will put up with things like this, but if done outside of factory, it's...

Well, got the pedal assy. Installed. Hadda drill a couple holes and modify one brace rod, but it's in! Also got trunk floor installed for converting to 68-70 Charger fuel tank(narrower than 66/7, and allows for 3" tail pipes when mini tubbed) or at least that's the theory.

Looking for headliner bow. I need the LARGEST ONE,but will take a set of four if reasonable. Thank you in advance.

Located. Thank you guys.

Located and have my pedal brackets thanks to this great bunch!!! Especially, Cop Car Wagon (Brent) Thank you gentlemen.

As soon as this is completely welded up. 3.73, Locker unit, 35 spline, 2" narrower each side for total of 4" narrow. With a 512 C.I. stroker and 4 speed, I'll need all the traction.

Of course, as the quarters are far different than a 66/7 Dodge Coronet or Plymouth belvedere.....

When I put inner wheel wells in, I hammered that area back.out almost flush with quarter panel so I should be good there. Also, a 60 series is taller than a 50. Mine is 295/50/15" much shorter than that 315/60/15"

As you can see a 295/59/15 fits with ample room to spare.

As you can see, this is alotta work. However, you can also see there's AT LEAST 14" of tire clearance. 15.5" wall to wall. If you trimmed the inner wheel wells lip back, you might even see 15" with 1/2" clearance each side. Definitely worth the work.

I didn't like the way this kit from UScartool did the rear shackle mount. Set up the way directions go, it raises your car about 2" in rear. I notched rear frame rails and simply remade it to fit in factory location. Is it correct? Is it nice as buying the weld-in parts? Nope, but does it work? Yes.

Yes! That's it. See your PMs please.