Recent content by dvader

Thx for your thoughts. That was kind of how I was leaning too but I was interested in what others rhought. Thanks again!

I am working on a 69 Road Runner. It is stock with all matching numbers except the engine which is a 71 383. Would it be worth my time to build a motor that is dated 69 for my car. I can get a 69 HP block for $400 and rebuild it but I am not sure it is worth the effort and money. The 71 in my...

You need to remove the tac and send it in and have it rebuilt. When you do that you can specify for MSD ignition. I had mine done. These factory tacs are not very accurate. Mine is slow reacting but is within 100 rpm.

I am interested in your 68 383. I am in Idaho. How much and what condition is it in? Thx. - - - Updated - - - I am interested 9n your 69 bl0ck. How much and what condition is it in? Thhx

I have a 69 Roadrunner with a 71 383. I am interestedin finding a 69 383 HP. Thx

Do you have the numbers from it? I am possibly interested.

That is my concern also. I am also wondering wondering about how well it will work in my car since cruising speed is about 3000 rpm instead of 2000 like the newer applications. Thx for your imput.

I need to change out my exhaust system. I have 69 Roadrunner with a stock 383 that I use for street and show. I want a system that has minimal drone, since I am 100 miles from the nearest city of any size, but has some bark when I get on it. I am interested in Dynomax VT muffler. Does anyone out...

Thanks guys. I found it on right side below the ignition switch just like you said. Not easy to get to and not easy to hunt down. Thanks again.

I am trying to trace down a short in my Emergency Flasher circuit. I have found the turn signal flasher but I can't seem to locate the Emergency Flasher under the dash. This is in a 69 Road Runner. Thanks for your help.

I just rebuilt my rearend and had the same whine on deceleration. It turned out that the pinion nut was not tourqued enough. Good luck.

The new circuit board is supposed toeliminate the need for filter. Thx though.

I have a 69 roadrunner that has a MSD 6A ignition installed that I am trying to get a factory tac to work in. I sent the tac to Performance Car graphics to have it calibrated and have a new circuit board installed. I also sent the 6A box to MSD to fix the tac output which was bad. I hooked up...

I did not use any sealant on the new sensor and I went to the battery for the ground for the ohlm check. I will check from the sensor to the motor in the morning. My gas gauge works but is an after market sending unit with the gauge reading 5/8 when the tank is full. The factory oil sensor is...

I am trying to get the original temp gauge to work in my 69 Roadrunner. I have grounded the sensor line and the gauge will peg high. I installed a new sensor and tested the ohms on it which showed ~110 ohms at start up and dropping as the engine warmed up. The gauge does not do anything when...