dvw's latest activity
-
dvw replied to the thread 741 case 8 3/4 progress.A friend works with reared lubricants for an oil company. All he does is Ford stuff. They can now even mix and match ring and pinions. Doug -
dvw replied to the thread Rear carb/front carb.An Eddy carb is like most carbs. 2 mixture screws and a primary idle speed screw. Treat them the same as you would adjusting one carb...
-
I treat all four primary barrels the same. The engine idles off all four barrels and should be adjusted as such. Smog street hemis...
-
dvw replied to the thread 741 case 8 3/4 progress.Just because it’s a little noisy won’t cause a failure. Doug
-
dvw replied to the thread Leak at steering valve body.When they say mark the housing it has adjustment forward/back. Very sensitive. Doug
-
dvw replied to the thread Rear carb/front carb.Why would running both carbs have any effect on idle? It idles on both regardless of linkage. We’ve run all our dual Eddys together, not...
-
dvw replied to the thread 741 case 8 3/4 progress.Did you add the additional shim I suggested? Was this a new gear? Even then sometimes they’re still noisy. Of all the stuff I do (and I...
-
dvw replied to the thread Helmet options.I’ve been using G Force for my last two. They fit pretty well. Doug
-
dvw replied to the thread When installing timing cover, h2o pump/housing.If you didn’t pull the pan I’d RTV the bottom of the timing cover with no gasket. Coat both surfaces. This will allow the cover to...
-
dvw replied to the thread 727 rebuild help.For what its worth. We run 3 pin planets in 9 second stuff. Some NHRA stockers even remove 2 pinions from the 4 pinion style and run...
-
dvw replied to the thread 727 rebuild help..060”
-
dvw replied to the thread 727 rebuild help.Post #4 is correct. The plate location and 4 friction front clutch appear stock. This unit looks like it suffered from lack of cooler...
-
If said plate is flat, clean it and reuse it putting clean side towards the disc, make sure its FLAT Drum pistons push against thin...
-
Here we are waiting to qualify at the NHRA Division 7 race in Pomona California in Stock and Superstock. I did well at the last Vegas...
-
dvw replied to the thread Compression ratio limit with Felpro 8519 head gaskets? POSSIBLE UPDATE.If 2&4 (and 5) were steam cleaned there is coolant in those cylinders. The gasket doesn’t show an area where both cylinders would’ve...