Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Sorry I did not post that picture, yes. Although I'm not sure what else is supposed to be in there. No real good posts using the search engine and it not working when I got it I'm not sure.
I have a 1970 roadrunner I bought a couple years ago and the previous owner told me the horn did not work. After further investigation I found the relay fried and also the ground wire attached to the copper plate under the steering wheel. I hooked a battery charger to horn and it sounded very...
Iv had the dash apart multiple times and there is a 10-12 gauge black wire (negative) and a red wire the same size (positive). what are you exactly saying to do with those?. Just unhook one and tape it off?
1970 roadrunner with rally dash
Sorry after reading my post I had them flipped around. I installed autometer gauges. (Oil pressure, water temp, and volts) so can I leave factory Amp gauge disconnected at bulkhead connector under hood (pictured in first post) or does that negative and positive...
I am putting new connections on at the bulkhead inside and under the hood along with the blocks. I got the inside done and installed auto meter oil pressure, water temp, and volt gauge. My question is can i leave the factor AMP gauge unhooked at the bulkhead sense i got the autometer volt gauge...
I am putting new connections on at the bulkhead inside and under the hood along with the blocks. I got the inside done and installed auto meter oil pressure, water temp, and amp gauge. My question is can i leave the factor VOlT gauge unhooked at the bulkhead sense i got the autometer amp gauge...
This is how my tail lamp housing is grounded. I currently have alligator clips going straight to negative on battery sense it is relocated to trunk. I plan on making a permanent ground to body for both lamps this weekend.
I will definitely take a look at the harness along the footwell, maybe...
I have replaced the board on the back of cluster New factory water,oil, and fuel gauge. All new sending units. 2 different Voltage Limiters from RTE. Have a new dimmer switch that's going in before cluster goes back in