Recent content by fff_charger

Yes, installation is stock to a TEE. It has the normal lines and the separator installed.

Never thought about that. I am gonna drive around until I run out of gas (of course with a 2 gallon can in the trunk) and see how long it runs after the gauge says "E". I always assumed the gauge was relatively accurate. THANKS!

I have a 70 Charger R/T. I have had an issue ever since the rebuild was completed. When I put fuel in the tank I cannot fill it all the way. It backs up into the filler neck. When I do fill it too far it then vents out the cap. I remember installing the filler neck and it seemed to me the neck...

I used aftermarket rocker assemblies that hit the baffles welded to the inside of the stock valve covers. Sounded like valve train noise until we realized what was happening. Also don't skimp on those aftermarket rocker assemblies. Buy the best. I learned the hard way.

I am looking for the trim mouldings that separate the Woodgrain area from the vinyl area on an SE door panel. There are 2 on each front door that are shaped like a hockey stick blade and one straight one on each rear panel.

Did you ever have any luck on these? I am looking for a set too!

I see this has been 6 months ago. Do you still have the 1970 Charger SE for parts.