• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Recent content by HALIFAXHOPS

  1. HALIFAXHOPS

    FOR SALE NORS ECU

    Bump
  2. HALIFAXHOPS

    Overview of screws and nuts 71 RR

    MMC has some good guides also.
  3. HALIFAXHOPS

    FOR SALE Mopar C-4166-A ignition tester

    Bump
  4. HALIFAXHOPS

    FOR SALE Mopar NOS single point sets

    Bump
  5. HALIFAXHOPS

    FOR SALE Ignition troubleshooting guides

    Bump
  6. HALIFAXHOPS

    FOR SALE Slant HEI mounting plates

    Bump
  7. HALIFAXHOPS

    FOR SALE Mopar distributors

    Bump
  8. HALIFAXHOPS

    FOR SALE Refurbished slant six distributors

    Bump
  9. HALIFAXHOPS

    FOR SALE Distributor advance springs

    Bump
  10. HALIFAXHOPS

    FOR SALE NORS ECU

    NORS 80's Delco ecu good to 5500 rpm and just tested. Asking $85 and the ride.
  11. HALIFAXHOPS

    Fried hei module??

    HEI modules you have to use a .3 ohm coil Like a GM hEI or a Petronix III No ballast
  12. HALIFAXHOPS

    Fried hei module??

    lIKE THIS?
  13. HALIFAXHOPS

    Fried hei module??

    No just a ground from the battery should be fine.. I just know from testing them I have blown out a few because of power to it and a bad ground.
  14. HALIFAXHOPS

    Fried hei module??

    Sounds fried. Definitely will fry it if there was no ground also.
  15. HALIFAXHOPS

    Neutral Safety Switch Polarity?

    You have to make sure the NSS is matched with the rooster comb in the transmission also or it will not work properly. If it was rebuilt who knows what is in it. Also did you test the switch itself out of the transmission? I went through this goat rope.
See more
Back
Top