Recent content by hd4406z

Thanks, It's coming along. Always willing to help out in keeping these beauties on the road, good luck

finally found someone to weld fuel tank brackets and repaint undercarriage, today Installed fuel tank into place can now I can work on the suspension and fuel lines.

changing out the Tire and Rim combo. going from 15 x10 Cragers SST to 17 x 10 Magnums. making sure the measurements are correct for the size tires I can fit without rubbing

Hi QQBlue1, I saw you are still waiting for a reply and thought I could answer this as I have a few original fenders laying around. They are in either method, I am guessing depending on Plant built, a couple have heavy undercoating, which could be dealer or aftermarket. I choiced to fully paint...

Yes it is, done it a couple times. if you looked at mine I went the Classic Industries route and wish I would've tackled it again. Your restored looks better than my New. that is some good work.

That grille came out amazing!

Looks like that is the same spot I marked, just didn't seem too secure with the pins I am trying to use, one my other Chargers has the key style that would work, just not as nice as these as the post is too long to secure and if I tighten the bolt for clearance hits the door when opening and...

working on the dash and comparing gap before I install the gages.

Nice, would you mind sharing more on the hood pins? I was going to add, but any position that would look nice on hood would mess up the grille. Thanks

I can relate, I am at a stand still right now, waiting to get into a shop as they forgot to add the fuel tank brackets when they replaced the trunk floor. You have done a lot and that looks like a fun ride.

LMAO, I didn't say it wasn't a rust bucket. It was pretty bad Hunter Green 383 4sp car.

I see you have Kentucky Plates, you anywhere near Louisville? I sold one of my 68s up there when I lived near Knox in 1999. Indy has some great products makes life easier.

It looks good even in that stage, you did some amazing work. Thanks for sharing

Looks in better shape than your last Charger, good luck enjoyed your last posts

That is awesome, I have changed the rear as well. Went with PST Tubular front arms along with their kit.