hoover's latest activity
-
Hhoover replied to the thread More torqueflite games.I added a hole to the lever on the transmission so that at idle it would be just approaching the point that throttle pressure starts and...
-
Hhoover replied to the thread More torqueflite games.The weather finally cooperated yesterday. The transmission still does not shift right. I installed a stock valvebody, thinking I may...
-
Hhoover replied to the thread More torqueflite games.My service manual does not show this very clearly- how should the throttle valve be adjusted?
-
-
Hhoover replied to the thread More torqueflite games.I put it back together and now it seems better.. I put a piece of paper towel in that port and it doesn't blow out.
-
-
Hhoover replied to the thread More torqueflite games.The bore looks ok. The sealing rings are intact. The bigger ones are metal. The small one is plasticy
-
-
Hhoover replied to the thread More torqueflite games.It sure does blow fluid out of that one!
-
Hhoover replied to the thread More torqueflite games.The rings are still square in profile. There is some air coming from where the reaction shaft support rides in the hub of the drum...
-
-
Hhoover replied to the thread More torqueflite games.The clearance was on the high side of the tolerance listed in the service manual- actually a few thousandths over. I found a snap ring...
-
-
Hhoover replied to the thread More torqueflite games.The outer seal is intact. The inner might have been installed backwards. Had 2 burned steels , luckily I have parts. Going to do more...
-
HThe outer front seal is tricky. It’s hidden and not accessible with any tool. Gentle compression of the piston using Vaseline and 3 C...
-
Hhoover replied to the thread More torqueflite games.Thanks!
-
H@dvw would be the man to answer that.. he is the trans man...
-
Hhoover replied to the thread More torqueflite games.I dropped the valvebody and did an air test on the front and rear clutch apply ports. The rear makes a solid thud noise when air is...
