Recent content by hpg4815

I tried jacking it up on the oil pan rail without any bolt removal and it worked! Thanks so much. Been fighting this for half the day

Did you. Have to remove my h e m m m m minute mount bolt in the passenger side? Having the same challenge on my 82 charger with a 1969 440 RB block.

this is the one I got 75120 Polished Radiator Cap from us radiator. It states Polished Radiator cap. Gm, Ford, Dodge and various applications with Standard filler neck. 16 lbs. for a closed system. 2.20” in diameter. so looks like the cap is fine? I used the Prestone 50/50 Prediluted...

Off the electric fuel injection hand held LCD console. The EFI has a sensor that I have in a port on the back of the intake. Now thinking about it I think I bought the radiator cap. Is there a recommended one?

anyone know what size wire to run from the alternator to the battery in the trunk, or better yet a good how to to do this? I don't want to catch anything on fire. I have a 6GA currently that goes from the alt to around tieback side of the engine on the firewall and to the battery. I need the...

I’m dealing with this issue right now. I’m running a Saginaw tankless pump with a PSC external reservoir, Hydrotech hydroboost, Borgeson steering box, and a cooler. It sounds like I need to drain everything and start fresh. Maybe air is getting into the system, but I used Red Horse Performance...

Hi everyone. I’ve read through all the posts—very insightful, so thank you. I do have a scenario I’d like some perspective on. I’m running a 440 RB block with FiTech EFI (mentioning this because it hasn’t been professionally tuned yet, and a previous comment mentioned that a lean mixture can...

Apologies for the delay. I’ve been working on getting the part properly packaged and weighed so I can provide an accurate shipping cost. There’s been quite a bit of interest, and I haven’t had the chance to respond to everyone individually. Once it's fully packaged, I’ll reach out to the first...

I built these for my 72 Charger. Not sure what else they will fit but I got a lot of compliments on the quality and stability of them. I am far along with my car at this point and no longer need them. Wanted to see if anyone else can use them. 50 bucks plus shipping. You will need to buy the...

Dual snorkel air cleaner from 440 RB engine. 100.00 plus shipping or best offer.

Drive shaft worth anything?

Power steering brackets and pulley mounting plate for either a 318 or 440 RB block. Are these worth anything? If not I will scrap it.

but the one have on there now did better than the dual snorkel which is the recessed round 3". So I will just put my dual snorkel up for sale in case any one wants that. Thanks!

great vid! thanks

I do not have hood vents. I would need to run the vents to the front of the car somewhere