Recent content by jball1105

Thanks everyone for the help. Shout out to everyone who said check wheels, specifically icetech who asked about wheel spacers….the culprit. If I was more competent at this I would’ve got it way back in comment #4

I I do have disc brakes. Not factory, they are from Dr. Diff. It slows down when brakes are applied but doesn’t stop. I would think that would indicate issue at wheels or driveshaft?

Cool, thanks.

Here’s a video of the noise in action.

Yes I did. Didn’t find anything loose.

Ok so on to the next. I learn something new everyday.

Finally got a chance to get a video. Both axles spin but the driveshaft doesn’t move. If I just wiggle a wheel back and forth it seems to engage a bit but otherwise nothing.

For the record I have been following along with the jokes and thought they were pretty good. I have not had a chance to take any videos yet, but will post them when I can. I should’ve stated that earlier so nobody thought I was run off! I do appreciate the concern pedal2themetal. This forum can...

I thought for sure you all would be able to diagnose it based on my vague description . I will get some video tomorrow. Thanks!

Hey guys, Just ran to the gas station and I am hearing a new noise from my 63 Sport fury. Sounds like it is coming from the drivers side rear. It goes away under acceleration, but when I coast it clunks. I didn't see anything just looking under the car. I'm thinking driveshaft or axle...

So I should be looking for a new cable and not the housing? I’ll give brewers a call on Monday. Thanks!

I am struggling with the speedo housing on my 63 Sport Fury. The transmission is a T10 four speed. I ordered a speedometer housing for it (Threw a bunch of old parts away like an idiot). It is bullet shaped and nowhere near big enough to seal. The opening on the trans looks like it should...

I think I found where they go. Thanks

I ordered new door bumpers from Detroit Muscle for my 63 Sport Fury. Got them today but I can’t tell where they go! I don’t think the old ones were present when I started working on the car. Can anyone tell me where these things go?

If I remember correctly the casting on the block said my poly is a 1966 so not the original in the photo in this car. So at some point ( if this is the same engine) it was put in the ‘55 in the photo. unfortunately my dad passed away 9 years ago and my grandparents have been gone for decades so...