Recent content by JeffreyMopar

Yes I’ll disassemble down to the valley and see what’s happening in the lifter cam area

Yes will do all of that. Was running 10/40 on an older engine

I will hope that! Thanks!

No hole in rocker. For sure need all new lifters. Feeling slack in others

Whelp you were right! Worse than expected I have lost the push rod and have lots of slack in other rockers. Send help sos

Ok thank you for the tip and trick I will try that. If the valve is open won’t you hear the air and it would be functioning as normal? But I guess if it’s closed you’d know if there is a leak.

Hello All, I was driving my 70 Superbee and after stalling at a light I noticed a noise between a click and small knock to the engine not super loud but noticeable like a bad rocker or small knock. compression Tested all 8 cylinders and all but lovely #6 are performing at minimum 130 psi. #6 is...

please do tell ive only done a few rebuilds so always learning

thanks for input!

its debatable!... id have to learn a bit more about strokers in that case

on a numbers matching block?

ive got the crank too! yes you're right i should probably say im doing a 'build' but its the original engine so my head was thinking rebuild to a performance (non stroker) 383

yes i have no rods to begin with

i have no rods to begin with, just the block and heads and intake/exhaust manifold

Hello, i have a numbers matching Superbee, looking to do a mostly stock rebuild on it. What is your favorite go to source for quality 383 stock rebuild parts. Needs Everything, rings, pistons, rods, gaskets, seals, plugs, blots etc etc. Maybe do a mild cam. no drag racing just around town and...