kaj750's latest activity
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.Someone previously reminded me that I do not have a dial indicator. I need to make a mental note. LoL -
kaj750 replied to the thread 440 rebuild difficulty 1-10.Very true, but it's the one you mentioned and I was curious. I would also like to switch to a roller setup.
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.Got it. Oddly enough, it seems I've been in contact with Jim. I never followed up with him after my car went down, temporarily. Lost...
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.Thanks for the pointers. I'll try to find Lusk. I don't know what FABO is, though.
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.How many oil change would it take you to recover the $$$ spent on the roller set up?
-
kaj750 replied to the thread Power supply check to right side of gauge cluster..Got back into the car today. So, checking power at the plug that goes onto the prongs on the back of the circuit board. I have the...
-
Keep plugging along on finding help. There's bound to be someone.
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.There are none that I can find. At least none willing to help. I've offered to pay what I had to. Actually found one guy that didn't...
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.All I did was swap a rotor cap when the issue started. Again, it's a long story that I have documented in another thread. I won't bore...
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.Current issue is a long story. Short version: crazy detonation under load, especially with higher IATs. I'm slowly tuning it out, best I...
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.I'm torn between keeping the flat tappet and doing roller. I'm pretty sure all the extra zinc in my oil isn't the greatest for my...
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.I'm taking a running engine apart, looking for obvious defects and checking a few things, then putting it back together again with the...
-
That’s a Caliper. I have a blue-point one. Which is SnapOns low-line. I bought a set of micrometers from Harbor Freight because I...
-
Uhh, I really hope that you meant "Dingle-BALL" hone.
-
kaj750 replied to the thread 440 rebuild difficulty 1-10.LOL. Yes, the hoist and lift help TONS. It would be a bit easier if the car didn't take up 100% the length of the garage. I'll have to...