• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Recent content by Michael Mahoney

  1. Michael Mahoney

    Intake Valley Pan Issues

    Ross custom pistons.
  2. Michael Mahoney

    Intake Valley Pan Issues

    Couple of things. Try to answer some of your suggestions, I have an external fuel pump, so no internal fuel leak unless thru carbs. No big explosions or loud bangs. I did find that the PCV valve could bottom out in its fixture and loose vacuum (fixed that by drilling out the bottom of the...
  3. Michael Mahoney

    Intake Valley Pan Issues

    Hi all, I had a cylinder lose compression and was tearing down upper end, intake, heads, etc to check the cylinders (440-500 stroker). After removing the tunnel ram intake I noticed the valley pan had ballooned up. I have never encountered this before. Anyone have any thoughts as to what...
  4. Michael Mahoney

    WTB Crane Gold Roller Rocker Arm

    That looks a lot closer style wise. Can I get you to measure the same spots as the one I showed you earlier?
  5. Michael Mahoney

    WTB Crane Gold Roller Rocker Arm

    Thanks Kim, I do not think they will fit my set. They look a little different. I appreciate you looking. Have at it 4mulas.
  6. Michael Mahoney

    WTB Crane Gold Roller Rocker Arm

    Kim if you find your other rockers. Mine are for Edelbrock RPM heads. The measurements are 1.440 across the shaft area, 1.073 across the top, and .900 across the roller area. If you could PM me the info and price, I would appreciate it.
  7. Michael Mahoney

    WTB Crane Gold Roller Rocker Arm

    These look like a set that I have that was set up for a Stage V head. Not sure, or maybe just older.
  8. 1964 Dodge Polara

    1964 Dodge Polara

    I purchased the 64 Dodge Polara 500 as a partial built drag race car. It had no floorboards, interior, windows or door latches. The fella had built it with a partner in the 90's. The partner took the money and ran leaving him the car. It sat in his garage for 18 years. He got remarried and...
  9. Michael Mahoney

    WTB Crane Gold Roller Rocker Arm

    The Crane catalog lists the rockers as 64750R or L-1. I cannot find what the C-06 stamped on the rocker arm stands for?
  10. Michael Mahoney

    WTB Crane Gold Roller Rocker Arm

    The L does indicate a left hand roller rocker. I took a photo of it for reference on the part number. The one my engine didn't like is a right hand roller rocker.
  11. Michael Mahoney

    New to Forum

    Thanks so much for the hello's. Where do I post my build photo's. Just pick a forum?
  12. Michael Mahoney

    New to Forum

    I have been watching this Forum for some time and finally needed to start a thread to look for a part. I am building a 64 Dodge Polara 500 for the strip. Been a MOPAR person for longer than I care to think about. Looking forward to lots of great information and help.
  13. Michael Mahoney

    WTB Crane Gold Roller Rocker Arm

    Hi, I am looking for a Crane Gold 1.5 Roller Rocker Arm for a B/RB 440 engine. I do not need a complete set, my engine only ate one. I need a right hand one, but will purchase more if you want to sell that way. The Crane part # is 64750R-1. Same as this, but would have R after the 1.5...
See more
Back
Top