Recent content by moparsrul

Thanks for the help much appreciated.

Can you change a push button 727 trans in a 64 to be used in a 65 with a colume or floor shifter? Have a pretty built trans. Out of a 64 that has been changed over to slip yoke and looking to see if I can use it in one of my it's.

P.M. message sent.

Pm sent.

P. M. sent

$9,500. possible trade big block motor, hemi parts or Mopar

Solid straight body the only rust is on the floor seen in pics. It has been painted plum crazy in the engine department plumbed with dual master cylinder and disc brakes on the front. It has a Chris Alston back half with a Dana 60 and a spool. 15" x 15" Weld wheels on the back I believe the...

1965 Plymouth Belvedere altered wheelbase. It was supposedly raced with a fuel injected Hemi at one time? Fiberglass fenders and bumpers. 8-3/4" rearend. I have a clean title in my name. have the front headlight bezels and a fair share of parts. I know the pics are terible but what I had .This...

pnora, you had something interesting. I have installed the blue 12V hot from the inginition switch with the blue wire from the box togetherthen attached them to the ballast resistor. The other side of the bastast resistor has a wire tothe positive on the distributor attached to a 12V only in...

Yes the unilite was. When I look at a wiring diagram it looks like the blue wire from the balast resistor goes back to the voltage regulator on a stock mopar alternator. The intall directions say the blue wire is the keyed hot 12v. I tested it and it is but as soon as you start cranking the...

Thanks I just wanted to make sure.

Wanting to install a Mopar performance electronic distributor in a 360 but it has a single wire alternator. Do I need to wire or do anything different than what's on the directions. It has a Mallory Unilite in it now. Thanks for the post!

Is this car still for sale if so can you send me the contact info.

Thanks I will measure that tonight.

Good point I will check into that.