Recent content by odin

I'd like to buy the center duct and plastic vent with fins if you will sell them alone.

I didn't word my post well. I have that piece but still need the big cover for the 904. I have two but I think they are both for a 727

I need the plate that covers the front lower half of the 904 when attached to a 318. Apparently the ones I have are for a 727 and not the correct fit for this 904 setup. Please let me know what you have and a cost shipped to CA 94534.

normally I would but this isn’t a very common issue and the OP might have learned an answer to the problem in that time. Not sure why it bothered you now that I think about it. Sorry if it did

I just had your exact experience. First set too short, second set too long. But mine is a 1976 318LA. Did you ever find the right set of studs?

PM sent

thank you very much for the response! I will keep looking.

the above post with the parts reference in the book indicates the same except one difference. The book says C10s go on the rear outer belts and you say C11s go there. How big of a difference is that? Only the length of the bolt or non-threaded portion of the bolt right? also, does every belt...

I’m in Fairfield. By chance do you have any 15” Rallyes?

copy, thank you. it did say that was the reason. I was up late so I wasn't sure if maybe I negotiated within the post by mistake or I wasn't supposed to negotiate in a PM. Regardless, payment sent this morning. Thanks for the clarification though!

I tried to PM you but I received a message this morning saying it was deleted for using PM to negotiate a price??

I am looking for a black center dash pad with AC vents and duct for a 68 Charger R/T with rallye dash.

Outstanding! That is exactly what I need. Thanks so much

Thanks! I already have the retractors and correct bolts. I ordered anchors that I will weld in place when I know the correct location for the bolt hole.

I am hoping someone has their 68 Charger in bare metal and can measure the location of the outer seatbelt anchor hole on the floor/rocker panel for each side.