Recent content by portsider44

I haven’t seen one before that has thick pad/bottle holes. May be someone just added them?

Found a box of parts during a garage clean. Parts I put back for my next project but raising kids and work got in the way. So after 20 years collecting dust they have seen daylight again. Did the hemi 4 speed come with a beefier inspection cover? This came off a 70 6barrel Roadrunner that...

Was saving these with hope of having for another project car. But not sure that next build is going to happen. At this point I have 3 really nice sets of trim. Photos is just one of the sets can post more if interested. $100 each free USPS shipping or will sell all 3 for $250 free shipping.

I know what you mean sold mine back in 1997. The things we do for wife and kids. It was my first BBody build after several Challengers and A Cuda. Now the kids are done with college and I have that itch for another Mopar.

I have an 11" inspection cover that I will take $65 plus shipping 456861[/ATTACH]"]

I contacted the seller & it is a K or 360 2bbl car. Does have tee tops but has no motor or transmission white with red int.

DO you have interest in a 79 GT, if so I think I know where one is & I can follow up on it

Pulling PVC causing a vacuum leaks helps it out? Sounds like it running rich? How the tail pipe look? Also might replace the condenser in the distributor. It cheap & can cause strange things to happen when it goes out. DO you have a timing light? Is the timing advancing as RPM are...

I prefer to put in as on unit, just need to raise the front end of the car allow more room for the transmission to go in downward angle.

I have been using Motorcraft on all my Mopars for the last 20 years & have no complaints. I have also used WIX, but mostly Motorcraft.

another A990 [/IMG] [/IMG]

I have a shifter & inspection cover fo sale in the parts section take a look if your interested

I have one that is that is in above avg-good condition I will take $200 & I will pay the shipping to the lower 48. I also have a 11" HD inspection cover that came out of a 70 6-pac roadrunner. This cover is heaver gauge metal then your run of the mill 833 covers. I will take $100 plus actual...