Recent content by Redhorse719

My project!

I thank all that has responded with ideas. I think I will just use E clips instead of the Mopar clip as suggested in the Charger section. It's not like I can get both hands into the opening at the same time to use a tool to install the factory clip. Which brings up " How did the factory...

It's been awhile since I was on the site, but now that I am trying to get my 66 Belvedere ready to cruise this summer I need some help with the quarter windows. The repair manual doesn't say anything about the clips that holds the rollers to the regulator. How has anyone that has replaced the...

My seat backs are like that with the exception of the wide chrome trim around the edge. My chrome trim is about the width of door edge guards. I saw a 67 GTX recently that had that wide trim like yours. Thank you 440 for all your help.

I bought these seats before I moved about ten years ago. They were sold as 66 B body seats I had no reason to believe they were not. The upholstery is long gone. Here is a picture of the seat tracks. The tape is on the inner track in the first picture. Thanks

I took the seat tracks apart to clean, paint and lub so they are not adjusted together. If you haven't installed your seats could you measure the location of the 4 holes? Thanks

I would think that if I set the tracks with the seat all the way forward then mark the inside studs and drill.

I have some 3/16 plate I had planned on making plates to weld to the floor.

This is the photo I got off the net, maybe this forum. It shows the tracks as being the same length. My inside track is shorter than the outside track. The outside track drops right in the bench seat holes.

These are exactly like mine with the adjustment slots. You can tell the inside track studs are more narrow than the outside. My problem is not knowing where to drill the inside holes. I already have several holes to weld up. Does anyone have the hole spacing for a 66 B body? Thanks 440

I'm back at it again, almost got my 66 Belvedere II back together during the Covid period. I'm working on installing the interior but ran into trouble with the seat tracks. The Belvedere was a bench seat car but I want bucket seats so several years ago I purchased BS and have since then...

Hawk, have you checked your milage yet? Curious to know what you are getting with the overdrive. Have a safe trip in your awesome car.

Hawk, it does look AWESOME!

I would pass on it based on this letter.

Can't answer your question on the sprag, but we would like to see pictures of your Dart. Especially under the hood.