Recent content by Redtunnel

I was just trying to share what I learned doing mine, hadn't really thought about fixing them for others. Thanks for asking though.

If you have an original rally dash clock that won't go "thunk" when power is applied I may have your fix. I just replaced points in a couple of these and they are working like new. It takes a little time, a set of points, some conductive glue (I used Anders Products Wire Glue), epoxy and a...

Great minds think alike, I was looking at that last night

I bought the tach not working off eBay hoping for something I could fix. I run an old accel dual point in the car . I looked down inside the tech body at the coils, all the coil connections attach to the board through the 4 brass rings in the center of the board, 2 appear to be ground. The...

I appreciate the replies and suggestions, if this was an original tic toc tach i would upgrade to the RTE board, it is an OER tach so the boards are not compatible. see the pictures of the board i am trying to find a schematic for. i tried to get a good picture of the front and back of the...

thanks Bob is yours an original? i have called some of the repair shops from the forum and i think any of their boards work on the originals but since this is after market they wont commit to it, that's why i was looking for a schematic to try and repair this one

I bought the Ebay special Tic Toc Tach. Ad said clock works tach doesn't. They were truthful, the board is roasted, OER does not sell replacement boards. Have searched the internet but come up empty, anyone else had a problem with one and taken it apart? check the picture. No picture of the...