• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Road Grabber's latest activity

  • Road Grabber
    Road Grabber replied to the thread Fuel pump?.
    Have you tried disconnecting the fuel line at the carb end and pumping the fuel into a container with someone cranking the engine?
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    and make sure you install the arm on the correct side.....
  • Road Grabber
    Road Grabber replied to the thread Fuel pump?.
    I can't really tell from the photo but as stupid as it may sound check your arrow direction that it's not in backwards.....
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    When you tighten the eccentric bolts it should squeeze up against the sleeves inside the bushings and tighten without crushing the poly...
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    So without the bushings installed the arm will fit inside the area. When you installed the bushings the setup is too wide. The bushings...
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    Need a picture of the other side
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    Someone is try to tell you something. No way would I bother at this point. I would mention these design flaws and send pictures for a...
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    Crazy. It's just a f'n press to install them. That sucks. If you had a big vice you could do it yourself with a piece of pipe on the...
  • Road Grabber
    I haven't seen a picture of the fuel line route but make sure the fuel line is away from the heater and radiator hoses. Check that your...
  • Road Grabber
    I had been tracking down an issue like this for years. I finally discovered that the heat riser shaft on the exhaust manifold was...
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    Even the originals can move without the sleeve pressed over the bushing from the other side. You will need a set of four collar sleeves...
  • Road Grabber
    Road Grabber replied to the thread Would you trust this?.
    My recollection is that those newer bushings resemble the original ones which don't just have a washer. It's a tube that has a washer...
  • Road Grabber
    Road Grabber replied to the thread Harland Sharp oiling issue?.
    Make sure you have the correct spacing between rockers that is given in the instructions. Also there is a specific number of threads to...
  • Road Grabber
    Road Grabber reacted to 451Mopar's post in the thread Harland Sharp oiling issue? with
    Like
    .
    I think the HS rockers have ball adjusters and use cup pushrods? With the ball adjuster, the oil hole is usually near the adjuster...
  • Road Grabber
    Useful. Thanks
Back
Top