Recent content by samanatoo

thanks will do I looked on the a12 site and they say the underside on originals are pretty rough and the year ones hoods are smooth and have a nice finish. my whole set up fits perfect for a repop. thx

just purchased a 69 bee. someone years ago added the lift off hood set up. How can I tell if it is an original hood???? anyhelp would be nice Thank you

I am getting ready to buy magnum 500s 15x7 and 15x8s. Willl magnums for fords have the same bolt patern as our 73 B bodies. These wheels I am looking at have 4.5 back spacing too. thx

thanks i will ck it out

Any pics would help too thx again

I have a 73 charger rallye with stock 14 inch rally wheels. Currently i have 215 70 14s. What would look better? 225 70 14s. Or. 235 60 14s. Or any other ideas.

cool I thought so. I just put in the new gas tank and would like to hang the valances so they do not get scratched from being stored.

Sounds kind of stupid but getting ready to put my bumpers back on my &# charger and it has been a few years. Should I install the valances front and rear first or should I install the bumpers and there brackets firsts?? I know I have to mount the brackets to the bumpers first right?? Help...

The original motor is fine I just bought a 340 cuda years ago that came with a fully rebuilt built long block. I figured I would put the 70 340 in the car and run her hard with no worries. The 70 340 has the X heads hotter cam aluminum intake and I am running a 750 holly the car should move...

Thx the 1970 340 has the smaller balancer on it already. This motor has 1969 date code. With Xs on the outsides. What are these heads?

AlsI have a original 727/340 charger. I am removing the orig 340 and intstalling a 1970 steel crank 340. Can i just remove the balancoe weight off the converter? Can i reuse the flexplate

I have a 1973 charger 727/340 cast crank motor. Original drivetrain. I know the torqueconverter has a balance weight because of the cast crank. Question is i am puting in a 1970 340 steel crank motor. Can i just remove the balance weight of my converter? Also can i reuse my flexplate...