Recent content by savoy

With no vin, Im guessin a warranty replacement.

Would an e-85 build on a 383 get him close to the 450- 500 hp mark?

Hey all! Im in the middle of building a 63 plymouth post car and have been lining up some parts to buy. I see alotta people using the the smaller floor pan sections, has anyone used the one piece setup for the early bs? How do they fit? Do they fit at all?

I have a 63 savoy that needs doors and youre right! Ive been looking for quite a few months now to find some. Your idea might be the way to go. Could you tell me a little more about whats all involved?

Looking for both drivers and pass. doors for a 63 plymouth savoy. Can be belvedere, Im not to picky.

Im pumped for ya! That rust is like a disease! Good ta see ya keep a positive attitude towards your project. Keep up the good work!

Thanks, I know that some of them I can make, but over the wheel well, uh no thanks.

Anybody know if there is an outfit out there that sells rear quarter patch panels for 63-65 savoy/belvedere?

checked into it. requires a new output shaft and tail housing. parts around $300.

Thats it Im movin!!!

Anybody ever use metal to metal instead of the fiberglass?

Might be more work than what its worth. Ill check with this Jaime @ Passon. Thanks for the tip!

Im building a 63 savoy and i ended up with an early style 4 speed with the flange. After doin some info hunting i found that I really dont want to use that style. Is it possible to swap the tail housing to a slip yoke style?

Wish I could say the same. Up here we still have a foot and half a snow. Great lookin car! What size slick are you runnin?

I agree. Love the look of a steelie! The dinner table is always nice to build carbs on!!