Recent content by Sheriffandy013

On your 18x10 set up, no custom work has been done or offset shackles meaning those dimensions should work on my 70 charger?

Ok, got her out! It’s for sale too! In the Mean time, I know vintage air has a nice block off plate with the kit but I won’t have funds for another year or so. I’m trying to get the thing together and running in the next couple months though. Does anyone else make a block off plate to cover...

At this point, it would likely cost 2gs to get the old one going again.

Yes, and if I go with the new system, what can I remove while it’s out?

Planning on installing this in the future on my 70 charger. My question is since I have the dash out now, what could I / should I remove to get ready for this. I figured removing heater/ac core now well be easier with dash out. I’m also torn, my car is an original ac car with small block. It...

Yes, I had one on my 68 but I got this one in pieces, haven’t seen one yet.

That’s not too bad! I going lime green, was hoping to powder coat same color

I do not, I think it was a pretty plain Jane 318 though. Thanks for the info! I do have them, they look to be original but ones took a decent wack at some point. I’ll leave them off if they are not necessary.

Yes, bumperetts is the question. They are not needed? Looks like a lot of cars without them? Just want to make sure not running then is ok. The ones on the car took a good wack at some point and the look without them is cleaner imo.

Yes, I did not mean abs…. Should read front and rear bumpers…also wanting theExterior trim for the car powder coated…70 charger. Are the lower support brackets needed for the front?

First, the lower bumper brackets on the front bumper, looks like a lot of people are leaving these off? Is this ok, cause any support issues? Second, I’m wanting to powder coat the front abs rear bumpers as well as the trim, going black, anyone else done this? Issues? Thanks!

Just waiting on the car to get back from paint, Dakota digital gauges, new bezels, painted the old trim. Scratched the dash pretty good trying to get gauges in…not happy about that.

That would be great!! Installing my new Dakota gauges and new dash bezel all around. Needed new screws anyway but now I can’t find the old ones to compare.

Ready to reinstall my gauge and radio bezel after getting dash painted. Gremlins obviously stole my screws…what are the correct sizes I should be using? All the same or are some longer or shorter? Also, there is only mounting tabs on the bottom of gauge bezel correct? Any help you can give is...