Recent content by shovelluv

First off, thanks for all the replies and info on the post. I contacted Comp and the guy told me they do not sell a pushrod for Mopar's that works with their cams, I explained my situation, flat tappet, and he said that Comp recommends using a bronze tip fuel pump pushrod. Which I can only...

I corrected , its 5000 not 500. I missed a zero

Ok, fair enough. but with all the issues over the past years, there should be somewhat of a consensus on what actually fixes the issue. So, I guess my question is to everyone is.. Who has the most miles on what setup, AFTER pushrod failure, assuming with the right oil?

Thanks for the reply.. Yes, When I did the assembly after rebuild, I made sure it the pushrod was in specs by using the SEARCH bar as moparedtn suggests.

Well, over the weekend my 1969 383 fuel pump quit pumping fuel. I removed the pump and rod today to find that the fuel pump pushrod is 1/4" shorter than it was 5000 miles ago. the motor was completely rebuilt with a mild to comp cam. I am running a factory style pump. So my question is... What...

Just wondering if anyone in a 200 mile radius of N.W. Indiana would have a nice original, clear, back glass for a 68-70 b body. I need it for a 69 roadrunner. Thanks

Im using the original intake and an 1/8" carb gasket.

I have not resolved it. Unfortunately, it is still the same way. I spoke with the Manufacture, about 6 months ago and he assured me that they were going to look into it. He did say that the seal was made to original specs. I tried everything I could to get the hood seal to go more towards the...

So Close... I have a 69 rr project car, from New Mexico, Im getting ready to start. 168442 I would love to find the original block.

Good evening, I am installing some front door glass channel run guides. Do they get 100% tucked into the channel? I found this photo on the web of this guy installing them and I see the channel guide is outside of the vent window frame channel which doesn't seem right to me. Thanks

Yes. It's the 383 base. I measured it to verify it was correct.

This is a 69 roadrunner with an n96 package, numbers matching. It is NOT an A 12 car.

I am not aware. please advise with the bunch of mismatched parts I have so I can fix this issue. This is my first full restoration to a 69 roadrunner. thank you

I recently finished restoration on my 1969 roadrunner. I purchased an air grabber seal / gasket for the duct to base from Detroit Muscle tech. My issue is the seal is bunching up on rear of the air cleaner lid and putting a lot of pressure on the original plastic ductwork and raising the center...

Was wondering if anyone had any extra 12x20 left hand thread wheel studs for a 1969 roadrunner 8 3/4. I am in N.W. Indiana