Recent content by steve maluk

Schumacher mounts correct / on the shelf / got a hemi 540 stroker to be honest wont put headers on a lawnmower done with headers blistered wires trouble changing plugs hammer on new headers went with stock hemi cast exhaust to make simple street weekend warrior car

want to mock up hemi with mount convertion before considering installing a hemi in my 69 RR i can get a k frame real cheap

Hello all Will a 1967 plymouth gtx Satellite Belvedere k frame work on a 1969 roadrunner? thanks all sjm

hello all Picked up a 69 RR replaced the gas tank and used the rubber seal that came with unit cant seem to keep gas from sloshing out the rear of tank . Replaced the gas cap any suggestions on a bad *** seal and possible bad *** gas cap. at this point i dont care about cost just want the fuel...

1973 challenger exhaust hangers i am running a duel exhaust on my 73 340 challenger all i see is only left side exhaust hanger is it known to put a left bracket on the right side? will need to drill holes to mount the right side if i use a left bracket am i missing something on a duel exhaust...

hello all 1973 challenger 340 automatic i dont know where the nox valve hoses go to can anybody help bottom of valve states carb but where at the carb and the top of valve nipple i have know clue. any pic would be great thanks sjm

hello all Sent my dash out to get recovered best time to go through my heater box my question is up at the front windshield is there a foam gasket that is adhered to the vent thanks all

i did not state sorry 1969 RR present 383 in car want to go 426 hemi are the inlet and outlet the same as the 383 motor radiator configuration thanks

hello all Is there a difference with radiators from a big block 383 b body RR and a 426 hemi inlet and outlet hose orientation. Presently my 383 both in and out are towards the driver's side of rad. Also want to go from 22inch to 26 inch with clutch fan. any help would be appreciated. thanks sjm

hello all restoring a 73 challenger had trans rebuilt but need a torque converter for a stock 340 with stock gear train any suggestions on a budget converter that will do on the street any stall suggestions thanks all

My roadrunner 1969 has the front fender support rod braces my 73 challenger does not were there any on the e body challengers there are factory holes on the bottom of fenders but dont know if they are for thanks all

hello all is the beep beep horn a roadrunner triggered with two horn steering wheel hits or is there something that automatically beeps twice when you hit the steering wheel once? thanks

It took a few weeks to solve this issue but the forum came thru. Thanks for all that respond. Steve