Recent content by superbirdtom

LOL well the washer trick wont work in this situation or this year of pedal assy. just getting the spring and pin in place i had to use superior mopar cunning. - and I wasn't going to loosen the pedal assy the cars all put together - so you all can see what i did- it worked great...

the spring is out of the car i managed to slip it back in. ill post pics of my Mcguyverism

aha only problem is w all those washers i wont b able to reinstall it as the car is done - it barley goes in without the washers. i think ill try hooking up the spring to the rear pin then take a come along and attach to a seatbelt bolt - ill use a strong wire to attach to the come along...

So like a total fool I installed the pedal system without putting in the center pin and the over center spring- its a complete resto so dash is in but seats I left out until very last ----so i can get under there laying on my back i managed to put in the pin and i slipped the spring into...

ive seen the one for $495- rebuilt one. not sure if i even want one yet, thanks!

ok - ill go on rock auto and ck it out. thx!

i read theirs one that works fine and looks ok for less than $100 but i cant find it any longer most likely a chevy one -thanks

hey anyone- i dont want to pay $500 for an idle solonoid- Ive heard theirs an alternative one that looks similar and is much cheaper ??? anyone know thanks!!

mabe something is overtightened - that makes sense - car is all together w/o seats - i think ill untighten the column first and see if something is binding. thanks!!!

ok great thats what i thought -well my tab wont move so its hanging up on something in the column Drat- and my key comes out and the steering wheel does not lock either - i wont install the lockout linkage yet until i get this figured out. I did complete nut an screw restoration - its...

rotates to accomplish what?

so i rebuilt my steering column with the tab that sticks out that the reverse lockout linkage hooks up to----My question is when putting 4 speed in reverse is the tube that has the tab poking out supposed to move up and down?? or is it just a pivot point? if its supposed to move up an down...

thank you the 7290 to 1350 joint worked. good site u have

I got the 7290 to 1350 and it worked out great!!!! had oreilly order it and came next day to alaska. thanks