Recent content by tlt23

Bars might be clocked? I haven't heard that term? I will adjust the bolts higher first, if that doesn't work it is the 440 bars going in for right now and call it good to ship. I'll update in a while

Ok, I'll try it again. I had the torsion bar out and everything hanging (had upper bump stop in place) tightened up all the bolts then installed the torsion bar and then began tightening the torsion bolt. on the front of the LCA the bolt that holds it in place should that be loosened and...

Next issue, I put my LCA back on reinstalled the torsion bar and adjusted, but the control arms sit on the bump stops, and the adjusting screws are all the way to the bottom of the LCA. When I pulled the LCA I pulled then completely out, welded up the stiffener plate on and then put new...

thank you all again for the help of this FN moron. I wish I would have just pulled the pedals apart and put the clutch pedal and housing on the frame that was in the car instead of taking the whole assy out and putting the complete assy in. would have saved time and frustration. lol I have to...

I got the brake booster loose and pulled from engine firewall. the back seems loose but I cannot get the front under the steering column free. I have the 2 bolts in the center out and the 2 nuts on the studs off and the studs out, and the one on the left that holds the shield on in the back...

gas brake clutch.. i know the gas is seperate but it still gives me 3 pedals. lol Sorry I was asking for pics not uploading mine. Do i have to remove the dash to get the auto pedal out and the clutch pedal assy in?

Hi again all. I am trying to take the two pedals out and put in the 3 with the Hyd master cyl on the firewall. Does anyone have good pics, I have the willwood master Cyl that comes with the MCcloud kit, but not sure if I have to drill a new hole for the rod or am I not looking in the right...

all I need help now with the neutral safety switch. now that it is a stick what do I do with the cable that went to the transmission that goes to the firewall? I was going to buy one from Brewers, but they are out until after next week. Can I cut the trans side, put pig tails on it and plug...

Looking to see what anyone has done to change the front brake hose for a 71 Charger. I have gone to every shop and Napa has 1 stock style on island, but I need both front. Has anyone changed to a newer style with banjo bolts or have another part number I can give NAPA to see if they might...

Thank you all again. I am in need of the length that the new driveline should be. I don't have the big yoke so ordered it, but checking to see if anyone who has done this knows off hand what it should be. I do appreciate all the help, trying to get this shipped by aug...

Thank you all for the great info. I was able to get the bearing from NAPA, they didn't have any of the smaller pilot bushings. I checked the depth of the shaft and the crank and I don't have to shave anything. I don't have an alignment tool, that is the next part of the quest how to align...

I have everything out and all parts acquired. I am trying to get the pilot bushing in the crank hole and have split 2 pilot bushing trying to get them in. What am I doing wrong. This is the last thing I have to do is get the clutch/pilot bearing in. from what I remember is that you either...

Next Question. nobody has a 130 tooth flywheel on island for a 318 because the computer doesn't tell them. Will a 6 bolt durango flywheel work too, if so what year.

I found them locally calling around to a bunch of different shops and 1 had them, got lucky. I read the torque should be 60lbs and the clutch bolts should be 35lbs is that right?

I found them there. Everything to Hawaii is crazy and taking forever. I will be calling them in the morning then and hopefully they have them in stock.