Recent content by vitamin c

Looks exactly like the starter on my 68

Very nice, thank you!

Can anyone tell me the torque rating for the aluminum intake manifold bolts, i cant seem to find it in my service manual.

Ok, thank you. On another note, did the original hood decal also cover the plastic air door? It's been so long i can't recall if i removed old decal from the plastic air grabber door or was it just paint?

Any updates on this? I've emailed Performance car graphics with no reply. I have the Phoenix decal but was unaware of no pre-cut hole, and would rather not attempt it if the correct decal is on the horizon.

I had a great experience with Bill and my Super Bee belts, then this debacle happened.

Surprisingly just got a response from someone via text, and im assuming it was Bill that read, "Trying to get them done today" My reply was that i am sympathetic to his health issues, but need them back finished or not. give me the cost for completed work with shipping. Ill wait a bit and see...

And how do you get a hold of her????

The scary part is he's apparently still been taking on new work! He's had my belts for over two years. After reading these posts, what i thought were legitimate excuses have seemed to have been used on everyone. At this point id be glad to get them back unfinished. Today i called his cell, his...

I also posted on the other thread, but unfortunatly im another one waiting over two years now. He currently has belts out of my super duty trans am, and ive heard every excuse under the sun. My guess is im screwed and will need to start the hunt for new replacement belts.

I need to get in on this. I sent Bill a set of Pontiac Super Duty Trans Am seatbelts in November of 2021 and have heard the all same as i read here. They are on the bench now! They are almost done! should be spring! The wife actually told me at one point she packed away all the belts and would...

Id be interested in your carb, if your open to offers. Im in Holland , so i wouldnt think shipping could be too bad.

What i have found with most hardware kits is they are not made for the 3'' shoes, so you end up with pins that are too short to secure the shoe to the backing plate. The last Napa kits i bought also had an incorrect spring that secures the self adjuster. What i found the toughest is the front...

Interesting your car has resonators. I've always thought they were on Hemi's or in some cases six packs

I just reinstalled the Hemi in my 68 Charger through the top and it was one of the easiest installs I've ever done. I installed it with the clutch and bell on the motor and put the 833 in from underneath.