Recent content by wedgie

You kept the cable operated poly 727?

Did you change the original 318 poly?

Convertor for the '64 727? Stock early input or did you put later model input in it?

New car shopping is a PITA. Ford has major issues with their water pumps because of location, GM has transmission issues, Stellantis has problems with everything. Hate to say it but Toyota seems to have the best vehicles right now. I'm in Oakland county and it's damn hot and humid. Waiting for...

B body wheelbase feels so much more stable through the traps than an A body as I recall. Raced them both. Nowhere near the power that you obviously have. I was doing 1320' not 660'. That's how long ago.

Quick and accurate way to check the interference angle is to have the car on jack stands, the back supported under the axle housing, measure the crank/trans angle by using a straight edge on the crank pulley and then using an angle finder or your phone to get the angle, then get the rear end...

They were much better before Ron died and the name was sold.

I put a wireless battery shutoff in my van. It's under the hood but unless you know what you're looking for, you would miss it. If it ever fails, I can simply take it out of the circuit and move on. Do need to carry an adjustable wrench and a screwdriver. Keeps driveaway thefts down. Tow trucks...

Wasn't the original "Ramchargers", Hodges Dodges, located in the Detroit suburbs? I used to drive past it in the early 60's.

Thank you, bolson6333

Looking for a decent original or a repop (if there are any). John

Perfect! Exactly what I needed, Thank you.

Can anyone share a picture of a properly installed trunk weatherstrip for an early B body? I need to know exactly where to glue it down. I remember that the ends butt up at the bottom. Thanks in advance. John

Thank you. Anyone know of a source for the clips shown?

Does anyone have a '63 Polara with bench seat and chrome hinge covers? I would appreciate seeing a picture or two. There are some on Ebay listed for different years, but I don't see how they would fit.