Recent content by Wholeshot

Repro or original?

Hammer, I would deliver it to the Nats if I could, but unfortunately, I don't have a vehicle, in which I could take the trans to the Nats. Thanks for your inquiry.

1965 Big Cable Shift, Slip Yoke, Transmission. Trans exterior is super clean. P/N stamped on case is 2466148. Mechanical condition unknown. Selling as a core. Local pick up only in northeast OH (Akron). $395

Attached is a photo of the heater control cable for a 65 B body w/o A/C. It is 22" long. It is in very nice condition. The cable moves freely. $20 + s/h from ZIP 44230

Hello, Are you selling the rubber boot, along with the column shift, and park, cables? If so, is the boot cracked, torn, melted, or damaged in any other way? Thanks, Jeff

Hello, I woud appreciate it if you would answer a few questions about the speedometer cable that you currently have listed For Sale. Is the cable still For Sale? Is the housing rusty anywhere? How long is the core inside the housing? How many teeth does the plastic gear have? Thanks, Jeff

Hello, Is the spring is for a 64/65 B body? Any wear or pitting on the outside of the spring? I look forward to hearing from you. Thanks

Hello Vic, I tried sending a PM but your Inbox is full.

Thanks for taking the time to respond to my post. I have seen transmission cooling line brackets that look similar, but not exactly like the one shown in my post. A trans cooling line bracket, that looks totally different from the one shown in my post, is being reproduced. Even if I find a...

Looking for a nice bracket like the one in the photo. I do not know if the bracket in the photo is from a B body. Even if you do not have a bracket to sell, like the one in the photo, if you know the P/N, or where this bracket was used (body, year, engine/trans), I would appreciateit if you...

Thanks so much for responding to my inquiry and for sending the photos. Much appreciated. Please let me know what you would charge to ship the yoke to Zip 44230. Thanks

Hi, I am interested in the yoke. I would appreciate it if you would answer a few questions. 1. Attached is one of your photos in which I added a couple of red arrows pointing to the areas where the U joint cups seat. I realize your yoke is new, however, I have seen some yokes where the...

I have a couple of different big block dual point distributor plates. Can you post a photo, looking down inside the housing that you plan to use with the plate? Some plates have a flat metal terminal tab, with a threaded hole to which the wire connects, that extend out thru a slot in the...