Recent content by wwheel

Thanks for the replies. I started with the top one and the new repro clip left a slight bulge in the vinyl after chiseling the board out as you pictured. Maybe it was the repro clips not sure. I just didn't want that bulge and so went with the Xmas trees. Anyway, it is done now. There was a hole...

I have seen one that was stamped metal and then the wire clips. I thought the stamped metal version was on early 60s. Any others? Using the Christmas trees make the issue of any misaligned holes and the time to cut the holes out go away. Took 5 minutes to install with the trees.

I gave up on the wire panel clips. 1) Too hard and time consuming to cut the openings 2) the cut outs were mostly in the wrong place on the Legendary panel 3) almost impossible not to have a lump show on the vinyl side. What I used instead is a Christmas tree fasteners with a 9/32" diameter...

Sale pending......

Offering a package of 36 Door Panel clips still in the bag. OER MM2367 fits a wide variety of B bodies. Typically $30 retail for clips only - I am selling for $16 which INCLUDES US shipping.

I Have a question about the clip placement on the rear panel. I measured the position of the holes for the clips on the inner Qtr. panel and compared those to the cut outs on the door card. See attached. The black "+" are where the holes in the inner panel are.They basically match up except for...

Now $75 WITH shipping in the US. That's $60 for the gear set or half price the price from 440 Source.

Without.

That is a great solution.

I have a brand new and still in the box gear set from 440 Source. Billet 3 Bolt 3 Way Adj. Timing Chain Set - New I am selling for $75 including shipping within the US. 440 Source price new is $126. Thank you, Wallace

Ok and thank you.

I bought a gear set for a roller cam (102-1004) from 440 source that does not have the Torrington bearing. Can you buy that separately and install or is the cam gear machined especially for the Bearing? I do have the cam button. Had no idea about the cover flex and good to know. Great thread!

Sale pending. I am checking on the I/O sizes and will get more pics today.

I have for sale (2) Hemi mufflers that were sold to me by Mitchell Motor Parts back in 1999. They apparently had a fire in their warehouse back then and when I got them on discount. I no longer need them and need to sell. They are in great shape other than the discoloration on the outside and...

What kit did you order? Zinc plating kit?