• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Recent content by ykf7b0

  1. ykf7b0

    Powerglide VS Torqueflite

    An old school 4 speed manual fun fact for you.
  2. ykf7b0

    Happy Mother's Day to all the ladies out there who qualify . . .

  3. ykf7b0

    Looking to build a 440. Got a couple options on Blocks.

    Be sure you get the main bearing caps when buying a bare block.
  4. ykf7b0

    FOR SALE 1968 Plymouth GTX parts group (no car)

    Thank you very much '68 for showing me this and I'm going to buy that one on e-bay! Mine is missing and I wasn't sure how it is set up and assembled. Elijah
  5. ykf7b0

    FOR SALE 1968 Plymouth GTX parts group (no car)

    Would you have a rear quarter panel window roller? It is the one farthest to the rear and runs between the window regulator and a channel that is held on by two nuts. It has two rollers connected by a short pin/shaft and resembles a dumb bell.
  6. ykf7b0

    Wow it's COLD out there! What about your spot?

  7. ykf7b0

    Merry Christmas 2024 *** Please post all your greetings here

  8. ykf7b0

    Alternator Replacement

    As previously stated, if 60amps are doing the job then "upgrading" to more amps isn't necessary but could be sketchy because your wiring might not be able to handle the extra amperage.
  9. ykf7b0

    Alternator Replacement

    I suggest NAPA.
  10. ykf7b0

    Tyson fight

  11. ykf7b0

    Tyson fight

    Well, if not for those two women really battling till the end, this whole fiasco would have been a total disaster.
  12. ykf7b0

    PTC converters

    I have had and currently have one of Kenny Ford’s PTC converters and I highly recommend this company to anyone needing a custom torque convertor. As a bonus, they are super nice and easy to talk to!
  13. ykf7b0

    Trickflow Valve Covers with 1.6 Rockers

    Do you have a roller cam and lifters installed as well? If so, those tend to be a little noisy compared to flat tappet.
  14. ykf7b0

    Replace gearbox and my steering wheel is slightly off, does this get an alignment?

    I think I would just reposition the wheel as long as the lock to lock turning radius isn't way off.
  15. ykf7b0

    camshaft recommendation

    I would base my selection on the engine compression ratio.
See more
Back
Top