ynst's latest activity
-
ynst replied to the thread What Size Brakes Do I Have?.Drum and disc brake systems operate on different pressures so, yes, you will need the proper proportioning valve as well as a disc/drum... -
ynst replied to the thread What Size Brakes Do I Have?.I measured the drums on the junk '69 Road Runner rear in my shed and they were just that, worn out and closer to 10-1/2 than 10 but they...
-
ynst replied to the thread What Size Brakes Do I Have?.drum/drum 11" rears disc/drum 10.5" rears
-
ynst replied to the thread Lights Dim at Idle.AND, your ammeter is moving to the "charge" direction every time you switch on the lights. i.e. you've rendered the ammeter useless as...
-
Incorrect procedurement having an ammeter on the charging line. Believe it or not, you are now overloading even more the aged wiring...
-
ynst replied to the thread Vibration on Highway at 60+."However if I raise the RPMs in neutral in that speed range, it does vibrate." It ain't the drive-line. It's the engine that's causing...
-
-
ynst replied to the thread Vibration on Highway at 60+.The tail-shaft bearing seems like a logical place to look. So does engine balance. Was the engine precision balanced or simply put...
-
ynst replied to the thread Removal of factory spray?.It does if you spray it over dirt because the dirt will encapsulate the moisture like a sponge. That's why Rusty Jones and similar...
-
-
ynst replied to the thread Electrical education?.I know the problem. I have to get out my penlight to distinguish some shades of brown and purple. I'm working on another whole-vehicle...
-
ynst replied to the thread Electrical education?.When I worked for a company upfitting first responder vehicles, the "lead electrician" was a licensed electrician...
-
-
ynst replied to the thread Electrical education?.It's been out of print for a number of years but you can still find it on the Internet. Written before engine management systems came...
-
-
ynst replied to the thread Pump gas 440 advice.premium gas Lucas ethanol additive hardened exhaust valve seats (on any pre-'72 vintage cylinder heads) I've always run premium since I...
-
ynst replied to the thread Brake flaring tool question.It ain't cheap anymore. I just ordered a couple of carb rebuilding kits from the UK and the duty nearly doubled the cost of my order...
-
ynst replied to the thread Left hand thread lugnuts.Can you say wobbly wheels? Better off using a press and supporting the flange AROUND the stud then gently pressing the stud out. Using...
-
